Do You Have Any Questions?

Toll-free (in the US): 1-866-ENDEVCO
Fax: 1-716-684-0987
Contact Endevco

We found 15 matches....
Model: 2777A-02-10

Model: 2777A-02-10

Diff. Remote Charge Convertor, Gain 2mV/pC, Lower Cutoff Frequency 10Hz

    Model: 2777A-02-15

    Model: 2777A-02-15

    Diff. Remote Charge Convertor, Gain 2mV/pC, Lower Cutoff Frequency 15Hz

      Model: 2777A-02-150

      Model: 2777A-02-150

      Diff. Remote Charge Convertor, Gain 2mV/pC, Lower Cutoff Frequency 150Hz

        Model: 2777A-02-20

        Model: 2777A-02-20

        Diff. Remote Charge Convertor, Gain 2mV/pC, Lower Cutoff Frequency 20Hz

          Model: 2777A-02-25

          Model: 2777A-02-25

          Diff. Remote Charge Convertor, Gain 2mV/pC, Lower Cutoff Frequency 25Hz

            Model: 2777A-10-10

            Model: 2777A-10-10

            Diff. Remote Charge Convertor, Gain 10mV/pC, Lower Cutoff Frequency 10Hz

              Model: 2777A-10-15

              Model: 2777A-10-15

              Diff. Remote Charge Convertor, Gain 10mV/pC, Lower Cutoff Frequency 15Hz

                Model: 2777A-10-150

                Model: 2777A-10-150

                Diff. Remote Charge Convertor, Gain 10mV/pC, Lower Cutoff Frequency 150Hz

                  Model: 2777A-10-20

                  Model: 2777A-10-20

                  Diff. Remote Charge Convertor, Gain 10mV/pC, Lower Cutoff Frequency 20Hz

                    Model: 2777A-10-25

                    Model: 2777A-10-25

                    Diff. Remote Charge Convertor, Gain 10mV/pC, Lower Cutoff Frequency 25Hz

                      
	Using single-ended accelerometers with the 2777A differential charge amplifier

                      Using single-ended accelerometers with the 2777A differential charge amplifier

                      h the 2777A differential charge amplifierUsing single-ended accelerometers with the 2777A differential charge amplifier Using single-ended accelerometers with the 2777A differential charge amplifier Question We are replacing our differential accelerometers with 7703A's that have single

                      
	Mounting differential remote charge converters

                      Mounting differential remote charge converters

                      ave a 2777A, but cannot find the mounting information. Answer The 2777A is a low noise, ruggedized remote charge converter for use with differential piezoelectric transducers. This device converts the transducer's high impedance charge input to a low impedance voltage output. The unit should be

                      
	Charge converter interface

                      Charge converter interface

                      C and 2777A have a DCV (direct current voltage) bias established at or near the mid point of the compliance supply voltage as shown in Figure 1. The DCV bias is common to most output stages of single ended devices allowing a dynamic AC signal to swing above and below the DCV bias operating point. Of

                      Considerations for using charge amplifiers with high temperature piezoelectric accelerometers

                      Considerations for using charge amplifiers with high temperature piezoelectric accelerometers

                      10 MΩ 2777A High Temp Diff 50 kΩ 6634C General SE or Diff 10 MΩ Table 2 [Source: Ref 1] Figure 1Several questions arise at this point: • Why does the accelerometer’s resistance drop? • How does a charge amplifier work? • Why do some charge amplifiers fail to work properly with low source resistances
                      EDV-TP-339

                      edv-catalog_lowres.pdf

                      edv-catalog_lowres.pdf

                      TEST & MEASUREMENT SENSOR CATALOG EXTREME ENVIRO